2010 Dodge Charger Engine Light On

If your dodge check engine light is on and you get code p0404 it means that your dodge exhaust gas recirculation egr valve is operating out of range.

2010 dodge charger engine light on.

Connect scan tool to the 16 pin data link connector dlc located near the steering column. You should take your dodge to a qualified mechanic to have the problem looked at and if necessary repaired before you reset the light. Follow scan tool manufacturer s operating instructions to access the diagnostic trouble. When retrieving dodge check engine light codes with an obd ii scan tool proceed as follows.

But if the light stays on or comes on while you re driving your car needs some love. If it doesn t you may see a wrench light or the check engine light instead. The purpose of the egr valve is to recirculate exhaust gases and send them back into the engine to lower the nox emissions. Four problems related to check engine light on have been reported for the 2010 dodge charger.

They are roughly ordered by importance which tends to be by color red amber yellow orange green blue gray but there are nearly 50 of them so be patient. The most recently reported issues are listed below. A check engine light can indicate a broad spectrum of problems with your 2008 dodge charger. Turn the ignition on.

The check engine light illuminates on the control panel on the dashboard of your dodge when the on board diagnostic computer reads a trouble code from the engine. You can reset the. The following are warning lights and indicators found in vehicles built by dodge. The throttle control warning light will normally light up briefly each time you start your vehicle and then go off.

This is nothing to worry about. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.